IP Networking Configuration
Configuration Guide 104 Document #: LTRT-31657
17.1 Example of multiple IPv6 Address Configuration
The following is an example of multiple IPv6 Address configuration.
17.1.1 Configuration
The configuration of two IPv6 addresses is shown below:
MSBR# configure data
MSBR(config-data)# interface gigabitethernet 0/0
MSBR(conf-if-GE 0/0)# ipv6 enable
MSBR(conf-if-GE 0/0)# ipv6 address 2001:100::1/64
MSBR(conf-if-GE 0/0)# ipv6 address 2001:200::1/64
17.1.2 70BOutput
The output of the show commands is shown below:
MSBR# show data interfaces gigabitethernet 0/0
GigabitEthernet 0/0 is Connected.
Description: WAN Copper
Hardware address is 00:90:8f:4b:fc:28
Port Link:UP
Port Speed : 1Gbps
Port Duplex:FULL
State Time: 0:00:20
Time since creation: 1:13:37
Time since last counters clear : 0:00:20
mtu auto
napt
IPv6 is enabled, link-local address is
fe80::290:8fff:fe4b:fc28/64
Global unicast address(es):
2001:200::1/64
2001:100::1/64
Joined group address(es):
ff02::1:ff00:0
ff02::1:ff00:1
ff02::1:ff4b:fc28
ff02::1
rx_packets 16 rx_bytes 1260 rx_dropped
0 rx_errors 0
tx_packets 5 tx_bytes 454 tx_dropped
0 tx_errors 0
15-seconds input rate: 1.3 Kbps, 2 packets/sec
15-seconds output rate: 0 bits/sec, 0 packets/sec
MSBR# show data ipv6 neighbors
To Next Page
Loading...
