IP Networking Configuration
Configuration Guide 130 Document #: LTRT-31657
20.5.6 Example of RA Configuration
The following is an example of Router Advertisement (RA) configuration.
20.5.6.1 Configuration
In this example, a host is connected to the LAN interface of MSBR on VLAN 1.
MSBR# configure data
MSBR(config-data)# interface vlan 1
MSBR(conf-if-VLAN 1)# ipv6 enable
MSBR(conf-if-VLAN 1)# ipv6 address 2001:100:1::1/64
MSBR(conf-if-VLAN 1)# ipv6 nd prefix 2001:100:1:: default
MSBR(conf-if-VLAN 1)# no ipv6 nd ra suppress
MSBR(conf-if-VLAN 1)#
20.5.6.2 Output
The following is the output of the ipconfig command at the host connected to the MSBR:
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix . :
IPv6 Address. . . . . . . . . . . :
2001:100:1:0:808e:a770:deb7:1cd3
Link-local IPv6 Address . . . . . :
fe80::808e:a770:deb7:1cd3%12
IPv4 Address. . . . . . . . . . . : 180.1.1.50
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : fe80::c800:24ff:fe90:8%12
fe80::c801:24ff:fe90:8%12
To Next Page
Loading...
