AudioCodes Mediant MSBR Series Configuration Guide

IP Networking Configuration
Configuration Guide 58 Document #: LTRT-31657
Command Description
(conf-router)# max-metric router-
lsa <administrative/on-
shutdown/on-startup> seconds
Configures the system to advertise
maximum-metric (infinite-distance) for OSPF
routes.
(conf-router)# neighbor
address
[poll-interval seconds] [priority
priority
]
Configures neighbor IP address when
connected to a non-broadcast network.
(conf-router)# network
prefix/length area area
Configures OSPF routing and advertisement on
an IP network.
(conf-router)# ospf abr-type
<cisco/ibm/shortcut/standard>
Configures the OSPF ABR implementation type.
(conf-router)# ospf
rfc1583comptibility
Enables the RF1583 compatibility flag (OSPF
cost calculation in summarized routes).
(conf-router)# ospf router-id
router-id
Configures the router-id for the OSPF process.
(conf-router)# passive-interface
interface
Configures an interface to not participate in the
OSPF routing.
(conf-router)# redistribute
<bgp/connected/kernel/rip/static>
[metric metric] [metric-type 1/2]
[route-map
map
]
Configures redistribution of routes from another
protocol into OSPF.
(conf-router)# refresh timer
seconds
Configures the refresh timer for LSAs in the
OSPF LSDB.
(conf-router)# router-id
router-id
Configures the router-id for the OSPF process.
(conf-router)# timers spf
chanedelay holdtime
Configures OSPF SPF timers: delay between
change and calculation, and the hold-time
between calculations.
(conf-router)# timers throttle spf
delay initialhold maxhold
Configures the OSPF hold timers: delay from
change to calculation, initial hold timer, and the
maximum hold timer.
11.2.1.2 Interface-Configuration Level
Command Description
MSBR# configure data
Enters the data configuration menu.
(config-data)# interface
interface
Enters the interface configuration mode.
(conf-if-
int
)# ip ospf
authentication [ address /message-
digest/null ]
Configures the type of OSPF authentication to
use on the specified interface.
(conf-if-
int
)# ip ospf
authentication-key auth-key
Configures the authentication key to be used on
the specified interface in case authentication is
configured.
(conf-if-
int
)# ip ospf cost
cost
Configures the OSPF cost for the specified
interface.
(conf-if-
int
)# ip ospf <hello-
interval/dead-interval> seconds
Configures the Hello and Dead timer for OSPF
to use on the specified interface.

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English