AudioCodes Mediant MSBR Series Configuration Guide

IP Networking Configuration
Configuration Guide 60 Document #: LTRT-31657
MSBR1(conf-router)# log-adjacency-changes
MSBR1(conf-router)# exit
MSBR1(config-data)# interface gigabitEthernet 0/0
MSBR1(conf-if-GE 0/0)# ip ospf hello-interval 1
MSBR1(conf-if-GE 0/0)# ip ospf dead-interval 3
MSBR2:
MSBR2# configure data
MSBR2(config-data)# router ospf
MSBR2(conf-router)# network 100.0.12.0/24 area 0
MSBR2(conf-router)# network 192.168.12.0/24 area 0
MSBR2(conf-router)# router-id 1.1.1.22
MSBR2(conf-router)# log-adjacency-changes
MSBR2(conf-router)# exit
MSBR2(config-data)# interface gigabitEthernet 0/0
MSBR2(conf-if-GE 0/0)# ip ospf hello-interval 1
MSBR2(conf-if-GE 0/0)# ip ospf dead-interval 3
11.2.3 Useful Output and show Commands
MSBR2# show data ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
RXmtL RqstL DBsmL
1.1.1.12 1 Full/Backup 38.143s 100.0.12.10
GigabitEthernet 0/0:10.31.2.8 0 0 0
MSBR2# # sh d ip route
Codes: K - kernel route, C - connected, S - static,
R - RIP, O - OSPF, B – BGP
C 1.1.1.22/32 [1/4] is directly connected, Loopback 1
C 100.0.12.0/24 [1/3] is directly connected, GigabitEthernet
0/0
C 192.168.0.0/24 [1/4] is directly connected, VLAN 1
O 192.169.12.0/24 [110/20] via 100.0.12.10,
GigabitEthernet0/0,01:30:46
MSBR2# show data ip ospf
OSPF Routing Process, Router ID: 1.1.1.22
Supports only single TOS (TOS0) routes
This implementation conforms to RFC2328
RFC1583Compatibility flag is disabled
Initial SPF scheduling delay 200 millisec(s)
Minimum hold time between consecutive SPFs 1000 millisec(s)
Maximum hold time between consecutive SPFs 10000 millisec(s)
Hold time multiplier is currently 2
SPF algorithm last executed 1m01s ago
SPF timer is inactive
Refresh timer 10 secs
Number of external LSA 0. Checksum Sum 0x00000000
A network learned via
OSPF protocol
OSPF Neighbor Details

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English