Version 6.8 145 Mediant MSBR
Configuration Guide 21. IP Multicast – PIM Sparse Mode
exit
interface VLAN 1
ip address 192.168.10.1 255.255.255.0
ip pim sparse-mode
mtu auto
desc "LAN switch VLAN 1"
no ipv6 enable
ip dhcp-server network 192.168.10.3 192.168.10.8 255.255.255.0
ip dhcp-server dns-server 0.0.0.0
ip dhcp-server netbios-name-server 0.0.0.0
ip dhcp-server lease 0 1 0
ip dhcp-server provide-host-name
ip dhcp-server ntp-server 0.0.0.0
ip dhcp-server tftp-server 0.0.0.0
ip dhcp-server override-router-address 0.0.0.0
ip dhcp-server next-server 0.0.0.0
service dhcp
ip dns server static
no napt
no firewall enable
no link-state monitor
no shutdown
exit
ip pim rp-address 200.0.0.2
ip nat translation udp-timeout 120
ip nat translation tcp-timeout 86400
ip nat translation icmp-timeout 6
# Note: The following WAN ports are in use by system services,
# conflicting rules should not be created:
# Ports 80 - 80 --> HTTP
# Ports 23 - 23 --> Telnet CLI
# Ports 22 - 22 --> SSH CLI
# Ports 82 - 82 --> TR069
ip domain name home
ip domain localhost msbr
pm sample-interval minute 5
pm sample-interval seconds 15
exit
# Running Configuration M500_Reciver
## VoIP Configuration
configure voip
interface network-dev 0
name "vlan 1"
activate
exit
interface network-if 0
ip-address 192.168.0.2
prefix-length 24
To Next Page
Loading...
