AudioCodes Mediant MSBR Series - Page 54

IP Networking Configuration
Configuration Guide 54 Document #: LTRT-31657
Command Description
name]
protocols into RIP.
(conf-router)# route
prefix
/
length
Adds a RIP static route.
(conf-router)# route-map
RMname
<in/out> interface
interface
Configures a route-map for the RIP routing.
(conf-router)# timers basic
value
Configures the routing table update timer.
(conf-router)# version <1/2>
Configures which RIP version to run.
Rip interface configuration:
Command Description
MSBR# configure data
Enters the data configuration menu.
(config-data)# interface
GigabitEthernet 0/0
Enters the interface configuration mode.
(conf-if-GE 0/0)# ip rip
receive
Rip version for received packets.
(conf-if-GE 0/0)# ip rip
send
Rip version for sent packets.
(conf-if-GE 0/0)# ip rip
split-horizon
Perform split horizon.
Rip general configuration:
Command Description
MSBR# configure data
Enters the data configuration menu.
(config-data)# key chain
Rip Authentication key management.