MSBR:
MSBR1# show data ip route
From input dev [VLAN 1] match up to ACL [130] route to
[GigabitEthernet 0/0] via GW [100.0.12.20]
Codes: K - kernel route, C - connected, S - static,
R - RIP, O - OSPF, B - BGP
S 0.0.0.0/0 [1/1] is directly connected, PPPOE
C 1.1.1.12/32 [1/4] is directly connected, Loopback 1
C 100.0.12.0/24 [1/3] is directly connected,
GigabitEthernet 0/0
C 192.169.12.0/24 [1/4] is directly connected, VLAN 1
C 192.169.1.0/24 [1/4] is directly connected, VLAN 2
MSBR1#
To Next Page
Loading...
