MediaPack Analog Gateways 21 MP-1288
Hardware Installation Manual 3. Physical Description
3.3.2 FXS Blades
The FXS blade (referred to as Module in the device's management interfaces) provides the
FXS port interfaces. Each blade provides three FXS port connectors - 50-pin Telco
connector (Centronics type). Each connector provides 24 FXS interfaces and therefore,
each blade provides up to 72 FXS interfaces (3 x 24 FXS). The device can be housed with
up to four FXS blades thereby, supporting up to 288 FXS port interfaces (4 blades x 72
FXS). The FXS blades are available as spare parts. For replacing FXS blades, see Section
6.2 on page 48.
Each FXS blade provides a LED on the front and rear panel, as described in Section
3.3.4.3 on page 25.
Figure 3-6: FXS Blade Showing Three FXS Telco Connectors
The chassis slot assignment for the FXS blades is shown in the figure below (front panel).
Note that the slot labels (S1, S2, S3 and S4) are located on the rear panel.
Figure 3-7: Chassis Slot Assignment for FXS Blades (Front Panel)
To Next Page
Loading...
