Hardware Installation Manual 38 Document #: LTRT-28030
5.3.2 Connecting FXS Interfaces using Centronics Cable
You can purchase AudioCodes' Centronics-type cable connector, as shown below, to
connect the FXS interfaces to FXS equipment. The 10-meter cable (32.8 ft.) provides a 50-
pin male Telco connector on one end and open leads on the other end, which need to be
connected to your patch panel or distribution frame.
Figure 5-12: Orderable Centronics Cable and Pinouts
To connect the FXS interfaces using the Centronics cable:
1. Connect the 50-pin male connector on end of the cable to one of the FXS blade's 50-
pin female Telco connectors located on the chassis' rear panel, and secure the
connector with the two captive screws located on either side of the connector, using a
Philips screwdriver:
Figure 5-13: Connecting 50-Pin Telco Connector to Port on FXS Blade
To Next Page
Loading...
