MediaPack Analog Gateways 35 MP-1288
Hardware Installation Manual 5. Cabling the Device
5.3.1 Connecting FXS Interfaces using AudioCodes FXS Patch Panel
You can purchase AudioCodes' FXS Patch Panel (shown below) to connect the FXS
interfaces to FXS equipment. The patch panel can be mounted in a 19-inch rack using
integrated mounting brackets and provides a 2-meter (78.7 in.) extension cable with a 50-
pin male connector for connection to the FXS port on the FXS blade .All incoming wires
from the 50-pin Telco connector are terminated to the back of the patch panel. The FXS
endpoints (e.g. telephones) can be plugged into the corresponding RJ-11 jacks on the front
of the patch panel.
Figure 5-7: Orderable FXS Patch Panel
To connect the FXS interfaces using the FXS Patch Panel:
1. Mount the Patch Panel in a 19-inch rack, using the integrated mounting brackets
located on either side of the Patch Panel. Use four 19-inch rack bolts (not supplied) to
securely attach the brackets to the front-rack posts. Make sure that the left and right
mounting brackets are attached to the rack posts at the same level so that the patch
panel is supported in a horizontal position.
To Next Page
Loading...
