AudioCodes MediaPack Series - Connecting to Power; Table 5-5: Power Specifications

Hardware Installation Manual 44 Document #: LTRT-28030
MP-1288
5.6 Connecting to Power
The device receives power from a standard alternating current (AC) electrical outlet. The
connection is made using the supplied AC power cord. The device can host up to two hot-
swappable Power Supply modules for load-sharing and power redundancy in case of
failure in one of the modules. To replace a faulty power supply module, see Section 6.5.
Table 5-5: Power Specifications
Physical Specification Value
Input Voltage
Dual universal AC power supply 100-240V 
AC Input Frequency
50/60 Hz
Max. AC Input Current
10 A
Max. Power Consumption FXS Interfaces Short Haul (W) Long Haul (W)
288
450 950
216
400 770
144
350 600
Note: If you are using two Power Supply modules, connect each one to a different AC
power supply source. The two AC power sources must have the same ground potential.
ご注意
本製品に添付の電源ケーブルは、MP-1288
に専用設計されているため、汎用性がありません.
本電源ケーブルを他の機器に使用されないよう、ご注意ください.