AudioCodes MediaPack Series - Figure 6-16: Tightening Captive Screws of FXS Blade on Front Panel

MediaPack Analog Gateways 57 MP-1288
Hardware Installation Manual 6. Hardware Maintenance
6. On the rear panel, secure the FXS blade to the chassis by inserting the hex-standoff
screws, using a 3/16-in. hex-head nut driver. Do not tighten the screws:
7. On the front panel, secure the FXS blade to the chassis, by tightening the two Philips-
head, captive screws on the front panel of the blade. You can use a Phillips or
flathead screwdriver:
Figure 6-16: Tightening Captive Screws of FXS Blade on Front Panel
8. On the rear panel, tighten the hex-standoff screws on each Telco connector of the
FXS blade, using a 3/16-in. hex-head nut driver.
9. On the front panel, re-install the Fan Tray module and Fan Tray cover, as described in
Section 6.2 on page 48.