AudioCodes MediaPack Series - Figure 5-18: Connecting Serial Interface

MediaPack Analog Gateways 43 MP-1288
Hardware Installation Manual 5. Cabling the Device
 To connect the serial interface port to a computer:
1. Connect the RJ-45 connector, at one end of the cable, to the device's serial port
(labeled |0|0|), located on the CPU module on the rear panel.
Figure 5-18: Connecting Serial Interface
2. Connect the DB-9 connector, at the other end of the cable, to a COM RS-232
communication port on your PC.
Note: The RS-232 port is not intended for permanent connection.