Hardware Installation Manual 28 Document #: LTRT-28030
To mount the device in a 19-inch rack:
1. Attach the two front-mounting brackets (supplied) to both sides of the chassis, as
shown in the figure below. Each bracket is secured to the chassis using 9 screws
(supplied).
Figure 4-1: Attaching Mounting Brackets to Chassis
2. With two people, lift the chassis into the rack from the front of the rack.
3. Hold the chassis for support while the second person positions the chassis in the rack
so that the front-mounting brackets are flush against the front-rack posts and that the
holes of the front-mounting brackets aligned with the holes on the front-rack post, as
shown in the figure below:
Figure 4-2: Front-Mounting Brackets Flush and Aligned with Front Rack Posts
4. Hold the chassis in position while the second person secures the two front-mounting
brackets to the front posts, by finger-tightening 19-inch rack bolts (not supplied) to the
rack posts. Each mounting bracket is secured to the rack by two bolts.
Note: Make sure that the left and right front-mounting brackets are attached to the rack
posts at the same level so that the chassis is supported in a horizontal position.
5. Tighten the bolts on the front-mounting brackets.
To Next Page
Loading...
