AudioCodes MSBG Series User Manual

User's Manual 1044 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
the transferred party answer. To enable answer
supervision, you also need to do the following:
1) Enable voice detection (i.e., set the
EnableVoiceDetection parameter to 1).
2) Set the EnableDSPIPMDetectors parameter to 1.
3) Install the IPMDetector DSP option Feature
License Key.
SMDI Parameters
Enable SMDI
configure voip > gateway voice-mail-
setting > enable-smdi
[SMDI]
Enables
Simplified Message Desk Interface (SMDI) interface
on the device.
 [0] Disable = (Default) Normal serial
 [1] Enable (Bellcore)
 [2] Ericsson MD-110
 [3] NEC (ICS)
Note:
 For the parameter to take effect, a device reset is
required.
 When the RS-232 connection is used for SMDI
messages (Serial SMDI), it cannot be used for other
applications, for example, to access the Command Line
Interface (CLI).
SMDI Timeout
configure voip > gateway voice-mail-
setting > smdi-timeout-[msec]
[SMDITimeOut]
Defines the time (in msec) that the device waits for an SMDI
Call Status message before or after a Setup message is
received. The parameter synchronizes the SMDI and analog
CAS interfaces.
If the timeout expires and only an SMDI message is
received, the SMDI message is dropped. If the timeout
expires and only a Setup message is received, the call is
established.
The valid range is 0 to 10000 (i.e., 10 seconds). The default
is 2000.
Message Waiting Indication (MWI) Parameters
MWI Off Digit Pattern
configure voip > gateway voice-mail-
setting > mwi-off-dig-ptrn
[MWIOffCode]
Defines the digit code used by the device to notify the PBX
that there are no messages waiting for a specific extension.
This code is added as prefix to the dialed number.
The valid range is a 25-character string.
MWI On Digit Pattern
configure voip > gateway voice-mail-
setting > mwi-on-dig-ptrn
[MWIOnCode]
Defines the digit code used by the device to notify the PBX
of messages waiting for a specific extension. This code is
added as prefix to the dialed number.
The valid range is a 25-character string.
MWI Suffix Pattern
configure voip > gateway voice-mail-
setting > mwi-suffix-pattern
[MWISuffixCode]
Defines the digit code used by the device as a suffix for
'MWI On Digit Pattern' and 'MWI Off Digit Pattern'.
This suffix
is added to the generated DTMF string after the extension
number.
The valid range is a 25-character string.
MWI Source Number
configure voip > gateway voice-mail-
setting > mwi-source-number
Defines the calling party's phone number used in the Q.931
MWI Setup message to PSTN. If not configured, the
channel's phone number is used as the calling number.

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English