AudioCodes MSBG Series User Manual

User's Manual 1048 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
CallerDisplayInfo_IsCidRestricted, CallerDisplayInfo_Module,
CallerDisplayInfo_Port;
[\CallerDisplayInfo]
Where,
 Module = Module number, where 1 denotes the module in
Slot 1.
 Port = Port number, where 1 denotes Port 1 of a module.
For example:
CallerDisplayInfo 0 = Susan C.,0,1,1; ("Susan C." is sent as
the Caller ID for Port 1 of Module 1)
CallerDisplayInfo 1 = Mark M.,0,1,2; ("Mark M." is sent as
Caller ID for Port 2 of Module 1)
For a detailed description of the table, see Configuring Caller
Display Information on page 582.
Note:
 The indexing of this table ini file parameter starts at 0.
 The parameter is applicable only to analog interfaces.
Enable Caller ID
configure voip > gateway dtmf-
supp-service supp-service-
settings
> enable-caller-id
[EnableCallerID]
Global parameter that enables Caller ID.
 [0] Disable (default)
 [1] Enable =

FXS: The calling number and display text (from IP) are
sent to the device's port.

FXO or CAS: The device detects the Caller ID signal
received from the Tel and sends it to the IP in the SIP
INVITE message (as the 'Display' element).
To configure the Caller ID string per port, see Configuring Caller
Display Information on page 582. To enable or disable caller ID
generation / detection per port, see Configuring Caller ID
Permissions on page 586.
Caller ID Type
configure voip > gateway dtmf-
supp-service supp-service-
settings
> ccaller-ID-type
[CallerIDType]
Determines the standard used for detection (FXO) and
generation (FXS) of Caller ID, and detection (FXO) / generation
(FXS) of MWI (when specified) signals:
 [0] Standard Bellcore = (Default) Caller ID and MWI
 [1] Standard ETSI = Caller ID and MWI
 [2] Standard NTT
 [4] Standard BT = Britain
 [16] Standard DTMF Based ETSI
 [17] Standard Denmark = Caller ID and MWI
 [18] Standard India
 [19] Standard Brazil
Note:
 The parameter is applicable only to analog interfaces.
 Typically, the Caller ID signals are generated / detected
between the first and second rings. However, sometimes the
Caller ID is detected before the first ring signal. In such a
scenario, set the RingsBeforeCallerID parameter to 0.
 Caller ID detection for Britain [4] is not supported on the
device’s FXO ports. Only FXS ports can generate the Britain
[4] Caller ID.
 To select the Bellcore Caller ID sub standard, use the

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English