AudioCodes MSBG Series User Manual

User's Manual 1050 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
sent to a currently busy telephone to display the caller ID of the
waiting call.
 [0] = Caller ID type 2 isn't played.
 [1] = (Default) Caller ID type 2 is played.
Note: The parameter is applicable only to FXS interfaces.
configure voip > interface fxs-fxo >
caller-id-timing-mode
[AnalogCallerIDTimingMode]
Determines when Caller ID is generated.
 [0] = (Default) Caller ID is generated between the first two
rings.
 [1] = The device attempts to find an optimized timing to
generate the Caller ID according to the selected Caller ID
type.
Note:
 The parameter is applicable only to FXS interfaces.
 If the parameter is set to 1 and used with distinctive ringing,
the Caller ID signal doesn't change the distinctive ringing
timing.
 For the parameter to take effect, a device reset is required.
configure voip > interface fxs-fxo >
bellcore-callerid-type-one-sub-
standard
[BellcoreCallerIDTypeOneSubSta
ndard]
Determines the Bellcore Caller ID sub-standard.
 [0] = (Default) Between rings.
 [1] = Not ring related.
Note:
 For the parameter to take effect, a device reset is required.
 The parameter is applicable only to FXS interfaces.
configure voip > interface fxs-fxo >
etsi-callerid-type-one-sub-
standard
[ETSICallerIDTypeOneSubStanda
rd]
Determines the ETSI FSK Caller ID Type 1 sub-standard (FXS
only).
 [0] = (Default) ETSI between rings.
 [1] = ETSI before ring DT_AS.
 [2] = ETSI before ring RP_AS.
 [3] = ETSI before ring LR_DT_AS.
 [4] = ETSI not ring related DT_AS.
 [5] = ETSI not ring related RP_AS.
 [6] = ETSI not ring related LR_DT_AS.
Note:
 For the parameter to take effect, a device reset is required.
 The parameter is applicable only to FXS interfaces.
Asserted Identity Mode
asserted-identity-m
[AssertedIdMode]
Determines whether the SIP header P-Asserted-Identity or P-
Preferred-Identity is added to the sent INVITE, 200 OK, or
UPDATE request for Caller ID (or privacy). These headers are
used to present the calling party's Caller ID, which is composed
of a Calling Number and a Calling Name (optional).
 [0] Disabled = (Default) P-Asserted-Identity and P-Preferred-
Identity headers are not added.
 [1] Add P-Asserted-Identity
 [2] Add P-Preferred-Identity
The
used header also depends on the calling Privacy (allowed or
restricted). These headers are used together with the Privacy
header. If Caller ID is restricted (i.e., P-Asserted-Identity is not
sent), the Privacy header includes the value 'id' ('Privacy: id').

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English