User's Manual 1090 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
as specified in GR-2865-CORE specification (default
behavior).
Note: When using the ini file to configure the device to support
several ISDNGeneralCCBehavior features, add the individual
feature values. For example, to support both [16] and [32]
features, set ISDNGeneralCCBehavior = 48 (i.e., 16 + 32).
Outgoing Calls Behavior
configure voip > interface e1-t1
bri > isdn-bits-outgoing-calls-
behavior
[ISDNOutCallsBehavior]
Determines several behaviour options (bit fields) that influence
the behaviour of the ISDN Stack outgoing calls. To select
options, click the arrow button, and then for each required
option, select 1 to enable. The default is 0 (i.e., disable).
 [2] USER SENDING COMPLETE =The default behavior of
the device (when this bit is not set) is to automatically
generate the Sending-Complete IE in the Setup message.
This behavior is used when overlap dialing is not needed.
When overlap dialing is needed, set this bit and the
behavior is changed to suit the scenario, i.e., Sending-
Complete IE is added when required in the Setup message
for Enblock mode or in the last Digit with Overlap mode.
 [16] USE MU LAW = The device sends G.711-m-Law in
outgoing voice calls. When disabled, the device sends
G.711-A-Law in outgoing voice calls.
Note: This option is applicable only to the Korean variant.
 [128] DIAL WITH KEYPAD = The device uses the Keypad
IE to store the called number digits instead of the
CALLED_NB IE.
Note: This option is applicable only to the Korean variant
(Korean network). This is useful for Korean switches that
don't accept the CALLED_NB IE.
 [256] STORE CHAN ID IN SETUP = The device forces the
sending of a Channel-Id IE in an outgoing Setup message
even if it's not required by the standard (i.e., optional) and
no Channel-Id has been specified in the establishment
request. This is useful for improving required compatibility
with switches. On BRI lines, the Channel-Id IE indicates
‘any channel’. On PRI lines it indicates an unused channel
ID, preferred only.
 [512] USE A LAW = The device sends G.711 A-Law in
outgoing voice calls. When disabled, the device sends the
default G.711-Law in outgoing voice calls.
Note: The option is applicable only to the E10 variant (T1
ISDN).
 [1024] = Numbering plan/type for T1 IP-to-Tel calling
numbers are defined according to the manipulation tables
or according to the RPID header (default). Otherwise, the
plan/type for T1 calls are set according to the length of the
calling number.
Note: The option is applicable only to T1 ISDN.
 [2048] = The device accepts any IA5 character in the
called_nb and calling_nb strings and sends any IA5
character in the called_nb, and is not restricted to extended
digits only (i.e., 0-9,*,#).
 [16384] DLCI REVERSED OPTION = Behavior bit used in
the IUA interface groups to indicate that the reversed format
of the DLCI field must be used.
To Next Page
Loading...
Need help?
General
