Version 7.2 1135 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
configure voip > sip-definition
settings > enum-service-domain
[EnumService]
e164.arpa, e164.customer.net, or NRENum.net.
The valid value is a string of up to 50 characters. The default
is "e164.arpa".
Note: ENUM-based routing is configured in the Tel-to-IP
Routing table using the "ENUM" stri
ng value as the destination
address to denote the parameter's value.
Use Routing Table for Host Names
and Profiles
configure voip > sip-definition
settings > rte-tbl-4-host-names
[AlwaysUseRouteTable]
Determines whether to use the device's routing table to obtain
the URI host name and optionally, an IP profile (per call) even
if a Proxy server is used.
 [0] Disable = (Default) Don't use the Tel-to-IP Routing
table.
 [1] Enable = Use the Tel-to-IP Routing table.
Note:
 The parameter appears only if the 'Use Default Proxy'
parameter is enabled.
 The domain name is used instead of a Proxy name or IP
address in the INVITE SIP URI.
Tel to IP Routing Mode
configure voip > gateway routing
settings > tel2ip-rte-mode
[RouteModeTel2IP]
Determines whether to route Tel calls to an IP destination
before or after manipulation of the destination number. This
applies to Tel-to-IP routing rules configured in the Tel-to-IP
Routing table.
 [0] Route calls before manipulation = Calls are routed
before the number manipulation rules are applied (default).
 [1] Route calls after manipulation = Calls are routed after
the number manipulation rules are applied.
Note:

The parameter is not applicable if outbound proxy routing is
used.
 For number manipulation, see ''Configuring
Source/Destination Number Manipulation'' on page 503.
 To configure Tel-to-IP routing rules, see ''Configuring Tel-
to-IP Routing Rules'' on page 475.
Tel-to-IP Routing table
Tel-to-IP Routing
configure voip > gateway routing
tel2ip-routing
[Prefix]
Defines Tel-to-IP routing rules for routing Tel-to-IP calls.
The format of the ini file table parameter is:
[PREFIX]
FORMAT PREFIX_Index = PREFIX_RouteName,
PREFIX_DestinationPrefix, PREFIX_DestAddress,
PREFIX_SourcePrefix, PREFIX_ProfileName,
PREFIX_MeteringCode, PREFIX_DestPort,
PREFIX_DestIPGroupName, PREFIX_TransportType,
PREFIX_SrcTrunkGroupID, PREFIX_DestSIPInterfaceName,
PREFIX_CostGroup, PREFIX_ForkingGroup,
PREFIX_CallSetupRulesSetId, PREFIX_ConnectivityStatus;
[\PREFIX]
For a detailed description of the table, see ''Configuring Tel-to-
IP Routing Rules'' on page 475.
IP-to-Tel Routing Table
To Next Page
Loading...
Need help?
General
