User's Manual 214 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
[DhcpServer_EndIPAddress]
The default value is 192.168.0.149.
Note: The IP address must belong to the same subnet as the
associated interface’s IP address and must be "greater or
equal" to the starting IP address defined in 'Start IP Address'.
Subnet Mask
subnet-mask
[DhcpServer_SubnetMask]
Defines the subnet mask (for IPv4 addresses) for the DHCP
client. The value is sent in DHCP Option 1 (Subnet Mask).
The default value is 0.0.0.0.
Note: The value must be "narrower" or equal to the subnet
mask of the
associated interface’s IP address. If set to "0.0.0.0",
the subnet mask of the associated interface is used.
Lease Time
lease-time
[DhcpServer_LeaseTime]
Defines the duration (in minutes) of the lease time to a DHCP
client for using an assigned IP address. The client needs to
request a new address before this time expires. The value is
sent in DHCP Option 51 (IP Address Lease Time).
The valid value range is 0 to 214,7483,647. The default is 1440.
When set to 0, the lease time is infinite.
DNS
DNS Server 1
dns-server-1
[DhcpServer_DNSServer1]
Defines the IP address (IPv4) of the primary DNS server that
the DHCP server assigns to the DHCP client. The value is sent
in DHCP Option 6 (Domain Name Server).
The default value is 0.0.0.0.
DNS Server 2
dns-server-2
[DhcpServer_DNSServer2]
Defines the IP address (IPv4) of the secondary DNS server that
the DHCP server assigns to the DHCP client. The value is sent
in DHCP Option 6 (Domain Name Server).
The default value is 0.0.0.0.
NetBIOS
NetBIOS Name Server
netbios-server
[DhcpServer_NetbiosNameServer]
Defines the IP address (IPv4) of the NetBIOS WINS server that
is available to a Microsoft DHCP client. The value is sent in
DHCP Option 44 (NetBIOS Name Server).
The default value is 0.0.0.0.
NetBIOS Node Type
netbios-node-type
[DhcpServer_NetbiosNodeType]
Defines the node type of the NetBIOS WINS server for a
Microsoft DHCP client. The value is sent in DHCP Option 46
(NetBIOS Node Type).
ï‚§ [0] Broadcast (default)
ï‚§ [1] peer-to-peer
ï‚§ [4] Mixed
ï‚§ [8] Hybrid
Time and Date
NTP Server 1
ntp-server-1
[DhcpServer_NTPServer1]
Defines the IP address (IPv4) of the primary NTP server that
the DHCP server assigns to the DHCP client. The value is sent
in DHCP Option 42 (Network Time Protocol Server).
The default value is 0.0.0.0.
NTP Server 2
ntp-server-2
[DhcpServer_NTPServer2]
Defines the IP address (IPv4) of the secondary NTP server that
the DHCP server assigns to the DHCP client. The value is sent
in DHCP Option 42 (Network Time Protocol Server).