Version 7.2 213 Mediant 1000B Gateway & E-SBC
User's Manual 15. Services
2. Click New; the following dialog box appears:
Figure 15-1: DHCP Servers Table - Add Dialog Box
3. Configure a DHCP server according to the parameters described in the table below.
4. Click Apply.
Table 15-2: DHCP Servers Table Parameter Descriptions
Parameter Description
General
Index
dhcp server <index>
Defines an index number for the new table row.
Note:
 Each row must be configured with a unique index.
 Currently, only one index row can be configured.
Interface Name
network-if
[DhcpServer_InterfaceName]
Associates an IP interface on which the DHCP server operates.
The IP interfaces are configured in the IP Interfaces table (see
''Configuring IP Network Interfaces'' on page 135).
By default, no value is defined.
Start IP Address
start-address
[DhcpServer_StartIPAddress]
Defines the starting IP address (IPv4 address in dotted-decimal
format) of the IP address pool range used by the DHCP server
to allocate addresses.
The default value is 192.168.0.100.
Note: The IP address must belong to the same subnet as the
associated interface’s IP address.
End IP Address
end-address
Defines the ending IP address (IPv4 address in dotted-decimal
format) of the IP address pool range used by the DHCP server
To Next Page
Loading...
Need help?
General
