Version 7.2 517 Mediant 1000B Gateway & E-SBC
User's Manual 24. Manipulation
Parameter Description
TON
ton
[_NumberType]
Defines the Type of Number (TON).
 [-1] = (Default) Not configured
 [0] Unknown (default)
 [1] International-Level2 Regional
 [2] National-Level1 Regional
 [3] Network-PSTN Specific
 [4] Subscriber-Level0 Regional
 [6] Abbreviated
The applicable values depend on the NPI value:
 If NPI is set to Unknown, you can set TON to Unknown.
 If NPI is set to Private, you can set TON to one of the following:
Unknown
International-Level2 Regional
National-Level1 Regional
Network-PSTN Specific
Subscriber-Level0 Regional
 If NPI is set to E.164 Public, you can set TON to one of the
following:
Unknown
International-Level2 Regional
National-Level1 Regional
Network-PSTN Specific
Subscriber-Level0 Regional
Abbreviated
For more information on available NPI/TON values, see Numbering
Plans and Type of Number on page 529.
NPI
npi
[_NumberPlan]
Defines the Numbering Plan Indicator (NPI).
 [-1] Not Configured = (Default) Value received from PSTN/IP is used
 [0] Unknown
 [1] E.164 Public
 [9] Private
For more information on available NPI/TON values, see Numbering
Plans and Type of Number on page 529.
Presentation
is-presentation-restricted
[_IsPresentationRestricted]
Enables caller ID.
 Not Configured = Privacy is determined according to the Caller ID
table (see Configuring Caller Display Information on page 582).
 [0] Allowed = Sends Caller ID information when a call is made using
these destination / source prefixes.
 [1] Restricted = Restricts Caller ID information for these prefixes.
Note: If you configure the parameter to Restricted and the
'AssertedIdMode' parameter to Add P-Asserted-Identity, the From
header in the INVITE message includes the following:
From: 'anonymous' <sip:
anonymous@anonymous.invalid> and 'privacy: id'
To Next Page
Loading...
Need help?
General
