User's Manual 516 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
[_SrcTrunkGroupID]
To denote any Trunk Group, leave this field empty. The value -1
indicates that this field is ignored in the rule.
Note: The parameter is applicable only to the Redirect Number Tel-to-
IP table.
Source IP Address
src-ip-address
[_SourceAddress]
Defines the IP address of the caller. The IP address appears in the SIP
Contact header of the incoming INVITE message.
The default value is the asterisk (*) symbol (i.e., any IP address). The
value can include the following wildcards:
 "x": represents single digits, for example, 10.8.8.xx denotes all
addresses between 10.8.8.10 and 10.8.8.99.
 "*": represents any number between 0 and 255, for example,
10.8.8.* denotes all addresses between 10.8.8.0 and 10.8.8.255.
Note: The parameter is applicable only to the Redirect Number IP-to-
Tel table.
Source Host Prefix
src-host-prefix
[_SrcHost]
Defines the URI host name prefix of the caller. The host name appears
in the SIP From header of the incoming SIP INVITE message.
The default value is the asterisk (*) symbol (i.e., any host name prefix).
Note:
 The parameter is applicable only to the Redirect Number IP-to-Tel
table.
 If the P-Asserted-Identity header is present in the incoming INVITE
message, the value of the parameter is compared to the P-
Asserted-Identity URI host name (instead of to the From header).
Destination Host Prefix
dst-host-prefix
[_DestHost]
Defines the Request-URI host name prefix, which appears in the
incoming SIP INVITE message.
The default value is the asterisk (*) symbol (i.e., any prefix).
Note: The parameter is applicable only to the Redirect Number IP-to-
Tel table.
Action
Stripped Digits From Left
remove-from-left
[_RemoveFromLeft]
Defines the number of digits to remove from the left of the redirect
number prefix.
For example, if you enter 3 and the redirect number is 5551234, the
new number is 1234.
Stripped Digits From Right
remove-from-right
[_RemoveFromRight]
Defines the number of digits to remove from the right of the redirect
number prefix.
For example, if you enter 3 and the redirect number is 5551234, the
new number is 5551.
Number of Digits to Leave
num-of-digits-to-leave
[_LeaveFromRight]
Defines the number of digits that you want to retain from the right of the
redirect number.
Prefix to Add
prefix-to-add
[_Prefix2Add]
Defines the number or string that you want added to the front of the
redirect number.
For example, if you enter 9 and the redirect number is 1234, the new
number is 91234.
Suffix to Add
suffix-to-add
Defines the number or string that you want added to the end of the
redirect number.
For example, if you enter 00 and the redirect number is 1234, the new
To Next Page
Loading...
Need help?
General
