EasyManuals Logo

AudioCodes MSBG Series User Manual

AudioCodes MSBG Series
1195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #667 background imageLoading...
Page #667 background image
Version 7.2 667 Mediant 1000B Gateway & E-SBC
User's Manual 33. Routing SBC
Parameter Description
handle them locally), set the parameter to "internal".
Destination Port
dst-port
[IP2IPRouting_DestPort]
Defines the destination port to where the call is sent.
Destination Transport Type
dst-transport-type
[IP2IPRouting_DestTransportType]
Defines the transport layer type for sending the call:
ï‚§ [-1] = (Default) Not configured - the transport type is
determined by the SIPTransportType global parameter.
ï‚§ [0] UDP
ï‚§ [1] TCP
ï‚§
[2]
TLS
IP Group Set
ipgroupset-name
[IP2IPRouting_IPGroupSetName]
Assigns an IP Group Set to the routing rule. The device routes
the call to one of the IP Groups in the IP Group Set according to
the load-balancing policy configured for the IP Group Set. For
more information, see Configuring IP Group Sets on page 674.
Note: The parameter is applicable only if you configure the
'Destination Type' parameter to IP Group Set (above).
Call Setup Rules Set ID
call-setup-rules-set-id
[IP2IPRouting_CallSetupRulesSetI
d]
Assigns a Call Setup Rule Set ID to the routing rule. The device
performs the Call Setup rules of this Set ID if the incoming call
matches the characteristics of this routing rule. The device
routes the call to the destination according to the routing rule's
configured action, only after it has performed the Call Setup
rules.
To configure Call Setup rules, see ''Configuring Call Setup
Rules'' on page 377.
Group Policy
group-policy
[IP2IPRouting_GroupPolicy]
Defines whether the routing rule includes call forking.
ï‚§ [0] None = (Default) Call uses only this route
(even if Forking
Group members are configured in the rows below it).
ï‚§ [1] Forking = Call uses this route and the routes of Forking
Group members, if configured (in the rows below it).
Note: Each Forking Group can contain up to 20 members. In
other words, up to 20 routing rules can be configured for the
same Forking Group.
Cost Group
cost-group
[IP2IPRouting_CostGroup]
Assigns a Cost Group to the routing rule for determining the
cost of the call.
By default, no value is defined.
To configure Cost Groups, see ''Configuring Cost Groups'' on
page 260.
Note:
ï‚§ To implement LCR and its Cost Groups, you must enable
LCR for the Routing Policy assigned to the routing rule (see
''Configuring SBC Routing Policy Rules'' on page 670). If
LCR is disabled, the device ignores the parameter.
ï‚§
The Routing Policy also determines whether matched routing
rules that are not assigned Cost Groups are considered as a
higher or lower cost route compared to matching routing
rules that are assigned Cost Groups. For example, if the
'Default Call Cost' parameter in the Routing Policy is
configured to Lowest Cost, even if the device locates

Table of Contents

Other manuals for AudioCodes MSBG Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MSBG Series and is the answer not in the manual?

AudioCodes MSBG Series Specifications

General IconGeneral
BrandAudioCodes
ModelMSBG Series
CategoryGateway
LanguageEnglish

Related product manuals