AudioCodes MSBG Series User Manual

User's Manual 934 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
[SNMPManagerTableIP_x]
Enter the IP address in dotted-decimal notation, e.g.,
108.10.1.255.
Trap Port
port
[SNMPManagerTrapPort_x]
Defines the port number of the remote SNMP Manager. The
device sends SNMP traps to this port.
The valid SNMP trap port range is 100 to 4000. The default
port is 162.
Trap Enable
send-trap
[SNMPManagerTrapSendingEnable_
x]
Enables the sending of traps to the corresponding SNMP
manager.
 [0] Disable = Sending is disabled.
 [1] Enable = (Default) Sending is enabled.
Trap User
trap-user
[SNMPManagerTrapUser_x]
Defines the SNMPv3 USM user or SNMPv2 user to associate
with the trap destination. This determines the trap format,
authentication level, and encryption level. By default, it is
associated with the SNMPv2 user (SNMP trap community
string).
The valid value is a string.
Trap Manager Host Name
manager-host-name
[SNMPTrapManagerHostName]
Defines an FQDN of the remote host used as an SNMP
manager to receive traps sent by the device. The device
sends the traps to the DNS-resolved IP address.
The valid range is a string of up to 99 characters.
For more information, see ''Configuring an SNMP Trap
Destination with FQDN'' on page 91.
Activity Trap
configure troubleshoot > activity-trap
[EnableActivityTrap]
Enables the device to send an SNMP trap to notify of Web
user activities in the Web interface. The activi
ties to report are
configured by the ActivityListToLog parameter.
 [0] Disable (default)
 [1] Enable
SNMP Community String Parameters
Read Only Community Strings
configure system > snmp settings >
ro-community-string
[SNMPReadOnlyCommunityString_x]
Defines a read-only SNMP community string. Up to five read-
only community strings can be configured.
The valid value is a string of up to 19 characters that can
include only the following:
 Upper- and lower-case letters (a to z, and A to Z)
 Numbers (0 to 9)
 Hyphen (-)
 Underline (_)
For example, "Public-comm_string1".
The default is "public".
Read/Write Community Strings
configure system > snmp settings >
rw-community-string
[SNMPReadWriteCommunityString_x
]
Defines a read-write SNMP community string. Up to five read-
write community strings can be configured.
The valid value is a string of up to 19 characters that can
include only the following:
 Upper- and lower-case letters (a to z, and A to Z)
 Numbers (0 to 9)
 Hyphen (-)
 Underline (_)

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English