User's Manual 974 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
Accounts
configure voip > sip-definition
account
[Account]
Defines user accounts for registering and/or authenticating
(digest) Trunk Groups or IP Groups (e.g., an IP-PBX) with a
Serving IP Group (e.g., a registrar server).
The format of the ini file table parameter is as follows:
[Account]
FORMAT Account_Index = Account_ServedTrunkGroup,
Account_ServedIPGroupName, Account_ServingIPGroupName,
Account_Username, Account_Password, Account_HostName,
Account_Register, Account_ContactUser,
Account_ApplicationType;
[\Account]
For a detailed description of the table, see ''Configuring
Registration Accounts'' on page 361.
Proxy Registration Parameters
Use Default Proxy
configure voip > sip-definition
settings > enable-proxy
[IsProxyUsed]
Enables the use of Proxy Set ID 0 (for backward compatibility).
 [0] No = (Default) Proxy Set 0 is not used.
 [1] Yes = Proxy Set ID 0 is used.
Note:
 The parameter must be used only for backward compatibility.
If not required for backward compatibility, make sure that the
parameter is disabled and use the Proxy Sets table for
configuring all your Proxy Sets (except for Proxy Set ID 0).
 If you are not using a proxy server, you must configure routing
rules to route the call.
 The parameter is applicable only to the Gateway application.
Proxy Name
configure voip > sip-definition
proxy-and-registration > proxy-
name
[ProxyName]
Defines the Home Proxy domain name. If specified, this name is
used as the Request-URI in REGISTER, INVITE and other SIP
messages, and as the host part of the To header in INVITE
messages. If not specified, the Proxy IP address is used instead.
The valid value is a string of up to 49 characters.
Note: The parameter functions together with the
UseProxyIPasHost parameter.
Use Proxy IP as Host
configure voip > sip-definition
settings > use-proxy-ip-as-host
[UseProxyIPasHost]
Enables the use of the proxy server's IP address (in dotted-
decimal notation) as the host name in SIP From and To headers
in REGISTER requests.
 [0] Disable (default)
 [1] Enable
If the parameter is disabled and the device registers to an IP
Group (i.e., proxy server), it uses the string configured by the
ProxyName parameter as the host name in the REGISTER's
Request-URI and uses the string configured by the IP Groups
table parameter, SIPGroupName as the host name in the To and
From headers. If the IP Group is configured with a Proxy Set that
has multiple IP addresses, all the REGISTER messages sent to
these proxies are sent with the same host name.
Note: If the parameter is disabled and the ProxyName parameter
is not config
ured, the proxy's IP address is used as the host name
in the REGISTER Request-URI.
Redundancy Mode Determines whether the device switches back to the primary
To Next Page
Loading...
Need help?
General
