AUMA AM 01.1 - Page 3

305.3. Accessories for electrical connection
305.3.1. Actuator controls on wall bracket
315.3.2. Parking frame
315.3.3. DS intermediate frame for double sealing
325.3.4. External earth connection
336. Operation................................................................................................................................
336.1. Manual operation
336.1.1. Engage manual operation
336.1.2. Manual operation: disengage
346.2. Motor operation
346.2.1. Local operation
356.2.2. Actuator operation from remote
367. Indications..............................................................................................................................
367.1. Indication lights
367.2. Optional indications
367.2.1. Mechanical position indication via indicator mark
388. Signals (output signals).........................................................................................................
388.1. Status signals via output contacts (digital outputs)
388.2. Optional signals
388.2.1. Analogue signals (analogue outputs)
399. Commissioning (basic settings)...........................................................................................
399.1. Heat-up time for low temperature version
399.2. Switch compartment: open
409.3. Torque switching: set
409.4. Limit switching: set
419.4.1. End position CLOSED (black section): set
419.4.2. End position OPEN (white section): set
429.5. Intermediate positions: set
429.5.1. Running direction CLOSE (black section): set
429.5.2. Running direction OPEN (white section): set
439.6. Test run
439.6.1. Direction of rotation at mechanical position indicator: check
439.6.2. Direction of rotation at hollow shaft/stem: check
449.6.3. Limit switching: check
459.6.4. PTC tripping device (option): test
459.7. Switch compartment: close
4610. Commissioning (optional equipment settings)...................................................................
4610.1. EWG 01.1 electronic position transmitter
4710.1.1. Measuring range: set
4710.1.2. Current values : adjust
4810.1.3. LED end position signalling: switch on/off
4810.2. Potentiometer
4810.2.1. Potentiometer: set
4910.3. RWG electronic position transmitter
4910.3.1. Measuring range: set
5010.4. Mechanical position indicator: set
5111. Commissioning – controls settings.....................................................................................
5111.1. Actuator controls: open
3
SA 07.2 – SA 16.2 /SAR 07.2 – SAR 16.2
AM 01.1/AM 02.1 Table of contents