AUMA AM 02.1 User Manual

295.4.1. Motor connection
295.4.1.1. Motor connection compartment: open
295.4.1.2. Motor cables: connect
305.4.1.3. Motor connection compartment: close
315.4.2. S/SH electrical connection (AUMA plug/socket connector)
315.4.2.1. Terminal compartment: open
325.4.2.2. Cable connection
335.4.2.3. Terminal compartment: close
345.5. Accessories for electrical connection
345.5.1. Actuator controls on wall bracket
355.5.2. Parking frame
365.5.3. DS intermediate frame for double sealing
365.5.4. External earth connection
376. Operation................................................................................................................................
376.1. Manual operation
376.1.1. Engage manual operation
386.1.2. Manual operation: disengage
386.2. Motor operation
386.2.1. Local operation
396.2.2. Actuator operation from remote
407. Indications..............................................................................................................................
407.1. Indication lights
407.2. Optional indications
407.2.1. Mechanical position indication via indicator mark
428. Signals (output signals).........................................................................................................
428.1. Feedback signals via output contacts (binary)
428.2. Feedback signals (analogue)
439. Commissioning (basic settings)...........................................................................................
439.1. Heat-up time for low temperature version
439.2. Switch compartment: open
449.3. Torque switching: set
449.4. Limit switching: set
459.4.1. End position CLOSED (black section): set
459.4.2. End position OPEN (white section): set
469.5. Test run
469.5.1. Direction of rotation at mechanical position indicator: check
469.5.2. Direction of rotation at hollow shaft/stem: check
479.5.3. Limit switching: check
479.6. Switch compartment: close
4910. Commissioning (optional equipment settings)...................................................................
4910.1. Potentiometer
4910.1.1. Potentiometer: set
4910.2. RWG electronic position transmitter
5010.2.1. Measuring range: set
5010.3. EWG 01.1 electronic position transmitter
5110.3.1. Measuring range: set
5210.3.2. Current values : adjust
5310.3.3. LED end position signalling: switch on/off
3
SA 25.1 – SA 48.1 / SAR 25.1 – SAR 30.1
AM 02.1 Table of contents

AUMA AM 02.1 Specifications

General

Brand	AUMA
Model	AM 02.1
Category	Controller
Language	English