Autonics TM4 Series User Manual

6 Parameter Settings and Functions
86 © Copyright Reserved Autonics Co., Ltd.
6.6.2.2 Alarm Output Upon STOP
 Enable or disable alarm output upon a stop.
 CONTINUE: Alarm output operates normally.
 OFF Alarm output ceases along with a stop under all conditions.
(However, reverting to Run mode after a stop in alarm latch or alarm latch and
standby sequence restores the alarm output to the previous state.)
Group Parameter Range
Factory
Default
Unit
Control Setting Group Stop Alarm Out
CONTINUE,
OFF
CONTINUE : -
6.6.3 Multi SV
 Multi SV function allows users to set multiple SVs and save each setting in SV0 ~
SV3. User can change Multi SV number or select desired SV using external DI
(Digital Input, DI-1, DI-2) terminal.
 This feature supports up to four SVs which can be independently configurable.
6.6.3.1 Number of Multi SVs
You can set the number of Multi SVs. Select the number of Multi SVs from the controlled
subject.
Number of SVs SV Assignment
1 EA SV-0
2 EA SV-0, SV-1
4 EA SV-0, SV-1, SV-2, SV-3,
6.6.3.2 Multi SV No. Change
You can select the SV to desired control.
The SV No. selection range varies according to the number of multi
SVs.

Autonics TM4 Series Specifications

General

Brand	Autonics
Model	TM4 Series
Category	Temperature Controller
Language	English