Avaya C360 - Page 109

System Logging
Issue 2 July 2005 109
- Log file – Informational
- Console – Informational
- Telnet/SSH session – Warning
● System Logging Commands
Tip:
Tip: The system logging configuration is not saved to NVRAM. The configuration only
affects the active session from which the commands are executed. Each session
must be configured separately.
● Clearing the system log file.
Tip:
Tip: Resetting the device does not clear the log file.
Use the CLI commands briefly described below for configuring System Logging. The rules of
syntax and output examples are all set out in detail in the Reference Guide for the Avaya C360
Converged Stackable Switch, 10-300506.
In order to... Use the following command...
Define a filter rule for logging
messages for the current
session
set logging session condition
Enable or disable logging for the
current session
set logging session {enable |
disable}
Display the logging configuration
for the current session
show logging session condition
Define a filter rule for logging
messages for a Syslog server
set logging server condition
Enable or disable logging for a
Syslog server
set logging server {enable |
disable}
Update the server facility
parameter of a configured
Syslog server
set logging server facility
Update the server severity
parameter of a configured
Syslog server
set logging server severity
1 of 2