Policy Configuration
Issue 2 July 2005 191
Policy Configuration CLI Commands
In order to... Use the following command...
Set the default action for a given
Policy List.
ip access-default-action
Create an access-list rule in a
specific Access List.
ip access-list
Set the source list, destination
list, and destination module for
copying an entire Policy List
ip access-list-copy
Set the DSCP-to-COS mapping.
Based on range and action
parameters, system will apply
mapping to frames
ip access-list-dscp operation
Designates which original frame
fields influence internal queues
selection
ip access-list-dscp trust
Assign a name to a Policy List ip access-list-name
Add the name of an owner to a
Policy List
ip access-list-owner
Delete an access-list element or
a Policy List
no ip access-list
Activate a Policy List ip access-group
Deactivate a Policy List no ip access-group
Display the DSCP to CoS map
of a policy-list
show ip access-list dscp
Set the list cookie for a specific
policy list
ip access-list-cookie
Display an access list show ip access-list
Activate the "simulate" process
for a packet containing a specific
field
ip simulate
Test the validity of a Policy List validate-group
Display the active policy-list
number
show ip access-group
1 of 2
To Next Page
Loading...
