Installing SFP GBIC Transceivers
Issue 2 July 2005 51
Copper GBIC Transceiver Installation Notes
Before installing a copper SFP transceiver, ensure that auto-negotiation is enabled for the
transceiver ports. You should also ensure that the auto-negotiation is enabled for the port at the
other end of the link:
1. Use the show port command to check the auto-negotiation status of the transceiver ports.
2. Use the set port negotiation <module>/<port> enable command to enable
auto-negotiation if necessary.
1000BASE-LX SM 9 N/A 10,000 2 1,310
1000BASE-ELX SM 9 N/A 70,000 10,000 1,550
Table 8: Gigabit Fiber Optic Cabling 2 of 2
Gigabit
Interface
Fiber
Type
Diameter
(µm)
Modal
Bandwidth
(MhzKm)
Maximum
Distance
(m)
Minimum
Distance
(m)
Wavelength
(nm)
2 of 2
To Next Page
Loading...
