Establishing Switch Access
84 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
RADIUS Commands
The following RADIUS commands are accessible from Supervisor level.
For a complete description of the RADIUS CLI commands, including syntax and output
examples, refer to the Reference Guide for the Avaya C360 Converged Stackable Switch,
10-300506.
Table 17: RADIUS CLI Commands
In order to... Use the following command...
Enable or disable authentication
for the C360 switch. RADIUS
authentication is disabled by
default
set radius authentication
Set a primary or secondary
RADIUS server IP address
set radius authentication server
Configure a character string to
be used as a "shared secret"
between the switch and the
RADIUS server
set radius authentication secret
Set the RFC 2138 approved
UDP port number.
set radius authentication
udp-port
Set the number of times an
access request is sent when
there is no response
set radius authentication
retry-number
Set the time to wait before
re-sending an access request
set radius authentication
retry-time
Remove a primary or secondary
RADIUS authentication server
clear radius authentication
server
Display all RADIUS
authentication configurations.
Shared secrets are not
displayed.
show radius authentication
To Next Page
Loading...
