Switch Configuration
98 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
System Parameter Configuration
Identifying the system
In order to make a C360 switch easier to identify, you can define a name for the switch, contact
information for the switch technician, and the location of the switch in the organization. The
rules of syntax and output examples are all set out in detail in the Reference Guide for the
Avaya C360 Converged Stackable Switch, 10-300506.
Return the prompt to its default
value
no hostname
Clear the current terminal
display
clear screen
Set the number of minutes
before an inactive CLI session
automatically logs out
set logout
Display the number of minutes
before an inactive CLI session
automatically times out
show logout
Access Layer 3 configuration if
not logged in as supervisor (see
Entering the Supervisor
Level on page 63)
configure
Table 23: Basic Switch Configuration CLI Commands 2 of 2
In order to... Use the following command...
2 of 2
Table 24: System Identification CLI Commands
In order to... Use the following command...
Configure the system name. set system name
Configure the system contact
person
set system contact
Configure the system location set system location
To Next Page
Loading...
