Avaya C360 - SMON CLI Commands

To Next Page

To Previous Page

Avaya C360 Layer 2 Features

150 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5

Note:

Note: SMON for the network layer is not supported in this version of the C360.

SMON CLI Commands

In order to... Use the following command...

Enter the SMON license set license

Display licenses installed on the

switch

show license

Main Page

Default Chapter3
- Table of Contents3
Before You Install the Avaya C36013
- Safety Information13
- Conventions Used in the Documentation14
  - CLI Conventions14
  - Notes, Cautions, and Warnings15
Section 1: Avaya C360 Overview17
Chapter 1: Avaya C360 Overview19
- C360 Features and Benefits20
- C360 Switch Configurations27
Section 2: Installing the C36029
Chapter 2: Avaya C360 Front and Rear Panels31
- C360 Front Panels32
- C360 Rear Panel37
Chapter 3: Installation39
- Preparing Needed Tools39
- Site Preparation40
- Rack Mounting (Optional)42
  - Before You Install the C360 in a Rack42
- Wall Mounting (Optional)44
- Stacking (Optional)45
  - Installing the X360STK Stacking Module45
  - Inter-Connecting Switches46
    - To Connect Stacked Switches46
- Making Connections to Network Equipment48
  - Prerequisites48
  - Connecting Cables to Network Equipment48
- Installing SFP GBIC Transceivers49
  - Safety Information49
    - Usage Restriction49
  - Installing and Removing a SFP GBIC Transceiver50
    - Copper GBIC Transceiver Installation Notes51
Chapter 4: Powering up the Avaya C36053
- Connecting to an AC Power Supply54
  - AC Power Cable54
- Connecting a BUPS55
- Post-Installation60
Chapter 5: Establishing Switch Access61
- CLI Architecture62
- Security Levels62
  - Entering the Supervisor Level63
    - Defining New Local Users63
    - Exiting the Supervisor Level63
- Entering the CLI64
- Establishing a Console Connection64
- Assigning C360 IP Stack Address66
- Establishing a Telnet Connection67
- Establishing an SSH Connection68
- Establishing Access to Other Entities in the Stack (C360 Sessions)72
- Establishing a Modem (PPP) Connection73
  - Connecting a Modem to the Console Port73
- SNMP Support75
- Radius82
  - Introduction to RADIUS82
  - RADIUS Commands84
- Recovery Password85
  - Introduction to Recovery Password85
  - Recovery Password CLI Commands85
- Allowed Managers86
  - Allowed Managers Introduction86
  - Allowed Managers CLI Commands86
- Allowed Protocols88
  - Allowed Protocols Introduction88
  - Allowed Protocols CLI Commands88
Section 3: Avaya C360 Configuration91
Chapter 6: Avaya C360 Default Settings93
- Configuring the Switch93
  - C360 Default Settings93
Chapter 7: Switch Configuration97
- Introduction97
- Basic Switch Configuration97
  - System Parameter Configuration98
    - Identifying the System98
    - Operating Parameters99
  - Network Time Acquiring Protocols Parameter Configuration99
- Uploading and Downloading Device Configurations and Images101
  - Layer 2 Configuration File102
  - Layer 3 Configuration File103
- SCP Protocol Support105
- System Logging106
  - System Logging Introduction106
  - Syslog Servers108
- Telnet Client Support111
  - Introduction to Telnet111
  - Telnet Commands111
- Monitoring CPU Utilization112
Chapter 8: Avaya C360 Layer 2 Features113
- Ethernet114
- Vlans120
- IEEE 802.1X (Port Based Network Access Control)126
- Spanning Tree Protocol131
- MAC Security136
  - MAC Security Implementation in the C360136
  - MAC Security CLI Commands137
- LAG (Link Aggregate Group)138
- Port Redundancy140
- IP Multicast Filtering144
  - Overview144
  - IP Multicast CLI Commands146
- Rmon147
  - RMON Overview147
  - RMON CLI Commands147
- Smon149
  - SMON Overview149
    - SMON CLI Commands150
- Port Mirroring151
- Weighted Queuing152
  - Implementation of Weighted Queuing in the C360152
  - Weighted Queuing CLI Commands152
- LLDP Agent153
Chapter 9: Avaya C360 Layer 3 Features157
- Obtaining and Activating a License Key158
  - Obtaining a Routing License Key159
  - Activating a Routing License Key165
    - License Key CLI Commands165
- What Is Routing166
- Routing Configuration168
  - Forwarding168
  - Multinetting (Multiple Subnets Per VLAN)168
- IP Configuration169
  - IP Configuration CLI Commands169
  - Assigning Initial Router Parameters170
- RIP (Routing Interchange Protocol) Configuration172
- OSPF (Open Shortest Path First) Configuration175
  - OSPF Overview175
  - OSPF CLI Commands176
- Static Routing Configuration177
- Route Redistribution180
  - Route Redistribution Commands180
- ARP (Address Resolution Protocol) Table Configuration181
  - ARP Overview181
    - The ARP Table182
  - ARP CLI Commands182
- BOOTP/DHCP (Dynamic Host Configuration Protocol) Relay Configuration183
  - BOOTP/DHCP Overview183
  - BOOTP/DHCP CLI Commands184
- Netbios Re-Broadcast Configuration185
  - Netbios Overview185
  - Netbios Re-Broadcast Configuration CLI Commands185
- VRRP (Virtual Router Redundancy Protocol) Configuration186
- Policy Configuration190
- IP Fragmentation and Reassembly194
  - IP Fragmentation and Reassembly Overview194
  - IP Fragmentation/Reassembly CLI Commands194
Chapter 10: Avaya C360 Power over Ethernet Features197
- Power over Ethernet198
Chapter 11: C360 Device Manager203
- Overview203
- System Requirements204
- Configuring the Device Manager204
  - Device Manager Commands204
- Running the Device Manager205
- Installing the Java Plug-In208
- Installing the On-Line Help and Java Plug-In on Your Web Site209
- Documentation209
Section 4: Troubleshooting and Maintaining the Avaya C360211
Chapter 12: Troubleshooting the Installation213
- Troubleshooting the Installation213
- Stack Health216
Chapter 13: Maintenance219
- Introduction219
- Replacing the Stacking Module219
- Hardware NVRAM Initialization220
Chapter 14: Updating the Firmware223
- Firmware Download223
  - Obtain Software Online223
  - Downloading Firmware223
- Download New Version Without Overwriting Existing Version224
  - Firmware Banks224
Appendix A: Mixed Stacks225
- Hardware Compatibility226
  - Stacking226
  - Bups227
- Feature Compatibility228
  - Qos Mapping229
Appendix B: Configuring C360 Qos for Avaya IP Telephones231
- Introduction231
Appendix C: Standards and Compatibility233
- Avaya C360 Standards Supported233
- IETF - Network Monitoring235
Appendix D: Specifications237
- Physical237
- Power Requirements237
- Environmental238
- Safety238
- Mtbf239
- Interfaces239
- GBIC Transceivers239
- Console Pin Assignments241
- Ethernet242
Index243

Avaya C360 - SMON CLI Commands

Table of Contents

Other manuals for Avaya C360

Related product manuals