Avaya C360 Layer 2 Features
118 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Ethernet Configuration CLI Commands
The following table contains a list of the configuration CLI commands for the Ethernet feature.
The rules of syntax and output examples are all set out in detail in the Reference Guide for the
Avaya C360 Converged Stackable Switch, 10-300506.
Table 30: Ethernet Configuration CLI Commands 1 of 2
In order to... Use the following command...
Enable/Disable MAC Aging set mac-aging
Set the MAC aging time in
minutes (0=don't age).
set mac-aging-time
Set the auto negotiation mode of
a port
set port negotiation
Administratively enable a port set port enable
Administratively disable a port set port disable
Set the speed for a 10/100 port set port speed
Configure the duplex mode of a
10/100BASE-T port
set port duplex
Configure a name for a port set port name
Set the send/receive mode for
flow-control frames for a full
duplex port
set port flowcontrol
Set the flow control
advertisement for a Gigabit port
when performing
autonegotiation
set port
auto-negotiation-flowcontrol-advertisement
Set the priority level of a port set port level
Display settings and status for
all ports
show port
Display per-port status
information related to flow
control
show port flowcontrol
Display the flow control
advertisement for a Gigabit port
used to perform auto-negotiation
show port
auto-negotiation-flowcontrol-advertisement
1 of 2
To Next Page
Loading...
