Spanning Tree Protocol
Issue 2 July 2005 135
Remove a port from the spanning
tree application
set port spantree disable
Set the port spantree priority
level
set port spantree priority
Set the cost of a port set port spantree cost
Set the port as an RSTP port
(and not as a common STA port)
set port spantree
force-protocol-migration
Display a port's edge admin and
operational RSTP state
show port edge state
Set the port as an RSTP edge
port or non-edge port
set port edge admin state
Set the port point-to-point admin
status
set port point-to-point admin
status
Show the port's point-to-point
admin and operational RSTP
status
show port point-to-point status
In order to... Use the following
command...
2 of 2
To Next Page
Loading...
