Avaya IX Collaboration Unit CU360 - Controlling Avaya IX CU360 with AT Commands

Name Description
OTA Update Enable The option to enable or disable remote access to the Over the Air
upgrade information on the public internet, and to alert users that a new
software version is available to upgrade Avaya IX
™
CU360.
Controlling Avaya IX
™
CU360 with AT commands
About this task
You can use AT commands to control the functions of Avaya IX
™
CU360 on the endpoint and web
interface.
Avaya IX
™
CU360 can receive AT commands from:
• The device network connection to the controller's IP address through the 55003 port.
• The device USB connection to the controller's serial port through a standard RS232 cable.
This configuration is available only if your administrator enables the advanced settings for users.
Procedure
1. Do one of the following:
• On the endpoint main menu, click Configure.
• On the web interface, click Administrator Settings.
2. On the endpoint, click Advanced.
The default PIN for Advanced settings on the endpoint is 1234.
If your administrator configured a PIN to gain access to the advanced settings on the
endpoint, Avaya IX
™
CU360 prompts you to enter the PIN. After you enter the PIN, Avaya
IX
™
CU360 displays the Advanced window.
3. Click Utilities > Remote Access > AT Commands.
4. Click one of the following in the AT Commands Management field.
• No: Disables the remote access to Avaya IX
™
CU360 using AT commands through the
TCP, SSH and RS232 serial port.
• IP only: Restricts the remote access to Avaya IX
™
CU360 using AT commands to only
the TCP connection.
5. Configure the following fields:
IP SSH RS232 Serial Port
Enable All Addresses Enabled Always Initialized
Address User Name Baud Rate
Subnet Mask Password —
Advance administration
April 2020 Installing and Administering Avaya IX Collaboration Unit CU360 110
Comments on this document? infodev@avaya.com