100
17. The equipment shall be used at a maximum ambient temperature of 40° C.
18. This unit may be provided with a power supply cord set suitable for 120V AC input only (for
U.S.A.and
Canada). For other than U.S.A. and Canada, a qualified person must provide for use
with this unit, an appropriate, approved power supply cord set which is in compliance with the
end use country requirements and has a minimum cross-sectional area of 1.0mm2.
19. For products with more than one power cord:
c
This unit has more than one power supply cord. Disconnect two power supply cords before
servicing to avoid electrical shock.
c
Cet appareil comporte plus d'un cordon d'alimentation. Afin de prévenir les chocs électriques,
débrancher les deux cordons d'alimentation avant de faire le dépannage.
20. For products with an operator-accessible fuse:
c
For continued protection against risk of fire, replace only with same type and rating of fuse.
c
Pour ne pas compromettre la protection contre les risques d'incendie, remplacer par un fusible
de m?me type et de m?me caractéristiques nominales.
Rack-Mount Requirements
1. Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment might be greater than room ambient. Therefore,
consider installing the equipment in an environment compatible with the maximum ambient
temperature (Tma) specified by the manufacturer.
2. Reduced Air Flow - Installation of the equipment in a ra
ck should be such that the amount of air
flow required for safe operation of the equipment is not compromised.
3. Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous
co
ndition is not achieved due to uneven mechanical loading.
4. Circuit Overloading - Consideration should be given to the connection of the equipment to the
su
pply circuit and the effect that overloading of the circuits might have on overcurrent protection
and supply wiring. Appropriate consideration of equipment nameplate ratings should be used
when addressing this concern.
5. Reliable Earthing - Reliable Earthing of rack-mounted equipment should be maintained.
Parti
cular attention should be given to supply connections other than direct connections to the
branch circuit (for example, use of power strips).
EMC (Electromagnetic Compliance) and Safety
Avid declares that this product complies with the following standards regulating emissions,
immunity and product safety:
• FCC Part 15 Class A
• ICES-003 Class A
• EN55032 Class A
To Next Page
Loading...
