81
d. Release the RAID controller by sliding it out of the chassis.
Replacing System Drives in the Chassis
Before you begin, make sure you have replacement system drives available for your FastServe | Live
Edit or FastServe | Ingest server.
n
The system should be taken offline and powered down before replacing boards.
To replace failed system drive:
1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on page 28
and “Safety and Regulatory Information”.
2. Power down the server and unplug all peripheral
devices and the AC power cables.
3. Remove the server cover as described in the Removing and Replacing the Server Main Cover
topic.
4. Disconnect any cables that might be in danger when you are replacing the drive.
5. Identify the system drive in your chassis:
To Next Page
Loading...
