75
5. Reconnect all peripheral devices and the AC power cords into the server.
Replacing Failed DVG Boards
In the event that you have one or more DVG board failures, you can replace them. First, you must
identify which board has failed. Then, once you know which board it is, you need to figure out when
you can replace it.
n
The system should be taken offline and powered down before replacing boards.
Before you begin, you must obtain replacement DVG boards for your FastServe | Live Edit or
FastServe |
Ingest server.
To identify and replace failed DVG boards:
1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on page 28
and “Safety and Regulatory Information”.
2. Power down the server and unplug all peripheral
devices and the AC power cables.
3. Remove the server cover as described in the Removing and Replacing the Server Main Cover
topic.
4. Disconnect any cables that might be in danger when you are replacing board.
5. Take out screws on the back cover, and slide the cover back to remove it from the chassis.
6. Identify DVG boards in your chassis:
To Next Page
Loading...
