35
To connect SDI video input cables:
1. Ensure that you have proper SDI video (75 ohm-rated) interface coaxial cables available.
2. Connect the SDI input signal to an incoming SDI input on the server.
3. 3.Connect the other end of all SDI input cables to your devices that are sending the input signal
to
the server.
Turning On the Server
When you turn on the power to your FastServe | Live Edit or FastServe | Ingest server, you must do
it in the following order so that it will see all of its connected components.
To turn on the power for each component:
1. Make sure you have all your network cables connected.
2. Push the power button at the top right on the front of the your server.
3. Log onto the server.
To Next Page
Loading...
