2 Installing the Server Hardware
This chapter describes how to install anFastServe | Live Edit or FastServe | Ingest server on your
site.
Topics in this chapter include:
• El
ectrostatic Discharge Precautions
• Installing FastServe | Live Edit / FastServe | Ingest Hardware in a Rack
• Installing the Drives in the Server
• Cabling the Server
• Turning On the Server
• Set
ting IPMI Connection
Electrostatic Discharge Precautions
Electrostatic discharge (ESD) can damage disk drives, cards, and other parts. Avid recommends that
you perform all procedures in this chapter only at an ESD workstation. If one is not available,
provide some ESD protection by wearing an antistatic wrist strap attached to chassis ground (any
unpainted metal surface) on your server when handling parts.
ESD and handling PCIe Cards
Always handle cards carefully. They
can be extremely sensitive to ESD. Hold cards only by their
edges. After removing a card from its protective wrapper or from the server, place the card
component side up on a grounded, static free surface. Use a conductive foam pad if available but not
the card wrapper. Do not slide the card over any surface.
To Next Page
Loading...
