50
Steps Required After OVS Installation
The following table provides a checklist of tasks that must be performed after installing Avid OVS
for the first time on a FastServe | Live Edit or FastServe | Ingest server.
Setting the Date, Time and Time Zone on the Server
You need to correctly set the date, time and time zone on each FastServe server.
To set the date, time and timezone options:
1. After installing the OVS, you need make sure to stop it before changing its parameters. Use the
following command to stop it:
/data/VS/bin/set_run -s all
2. To display the current time and date on your system, use the following commands:
timedatectl status
hwclock
3. If required, disable NTP (Network Time Protocol) and RTC (Real-time clock):
timedatectl set-local-rtc 0
timedatectl set-ntp 0
4. Check the current time zone:
ls -l /etc/localtime
timedatectl | grep -i 'time zone'
5. Change the time zone to the one you require (we will use Europe/ Warsaw and Asia/Jerusalem as
an example):
timedatectl set-timezone Europe/Warsaw
timedatectl set-timezone Asia/Jerusalem
6. Verify your time zone settings by typing the following commands:
ls -l /etc/localtime
timedatectl | grep -i 'time zone'
b
Set the date, time, and time zone settings, as described in the topic “Setting the Date, Time and Time
Zone on the Server” on page 50.
b
Set the CPU speed, as described in the topic “Setting the CPU Speed” on page 51.
b
Update the modeprobe.conf file, as described in the topic “Updating the modprobe.conf File” on
page 51.
b
Edit the Codecs file, as described in the topic “Editing the Codecs File” on page 51.
b
Update your license, as described in the topic “Updating Your License” on page 53.
b
Edit the vsPreferences.cfg file, as described in the topic “Editing the vsPreferences.cfg File” on
page 54.
b
Update the firmware of DVG boards, as described in the topic “Updating Firmware of DVG Boards”
on page 53.
b
Update the Avid registry, as described in the topic “Updating the AvidRegistry” on page 57.
To Next Page
Loading...
