3. Push the spring portion of the DIN rail mount onto one side of the DIN rail.
4. Rotate the other end of the unit towards the DIN rail until the mount snaps into place.
5. Connect the required cables. For more information, see Cable Connections below.
Cable Connections
Connecting the Ethernet and HD BNC Cables
Refer to the diagrams in the Main Unit Overview section for the location of the different connectors and
status LEDs on the main unit.
1. Connect a network cable to the unit's Ethernet port (RJ45 connector).
2. Connect an HD BNC cable for the number of imager modules you are installing. Up to two imagers can
be connected to each main unit.
3. If the camera is connected to any external devices, connect the I/O or audio cables to the I/O
connector block. For more information, see Connecting to External Audio and I/O Devices on the next
page.
Cable Connections 22
To Next Page
Loading...
