LED Behavior Suggested Solution
Both LEDs are off and the camera is not
connected or streaming video
Check the General setup page in the camera's web interface to
ensure the LEDs are not disabled.
If the LEDs are not disabled, perform a factory reset of the
camera using the physical firmware revert button. Resetting
through the camera's web interface will not produce the
desired result.
Both LEDs are blinking several times at
the same time, then pause and repeat the
blinking
Perform a factory reset of the camera using the physical
firmware revert button. Resetting through the camera's web
interface will not produce the desired result.
A different LED blinking pattern than
those described above
Perform a factory reset of the camera using the physical
firmware revert button. Resetting through the camera's web
interface will not produce the desired result.
Imager Connection LED Indicators
On the main unit, just above the HD BNC connectors are LED indicators for the HD BNC connection status.
There is a separate LED for each of the two HD BNC connections. For the location of these LEDs, see Rear
View on page9.
When an HD BNC connection is active, the LED will be on. The LED will be off when there is no active HD
BNC connection.
Troubleshooting Imager Connections and LED Behavior
If you have made an HD BNC connection and the LED remains off, try the following solutions:
l
Disconnect and reconnect the HD BNC cable to both the imager and the main unit.
l
Ensure the HD BNC connections are secure.
l
Check if the HD BNC cable has been damaged.
Imager Connection LED Indicators 53
To Next Page
Loading...
Need help?
General
