Avigilon H5A Series - Main Unit LED Indicators; Connection Status LED Indicator; Troubleshooting LED Behavior

Main Unit LED Indicators
Connection Status LED Indicator
Once connected to the network, the green Connection Status LED indicator will display the progress in
connecting to the Network Video Management software.
The following table describes what the LED indicator shows:
Connection State Connection Status
LED Indicator
Description
Obtaining
IPAddress
One short flash
every second
Attempting to obtain an IP address.
Discoverable Two short flashes
every second
Obtained an IPaddress but not connected to the
NetworkVideo Management software.
Upgrading
Firmware
Two short flashes
and one long flash
every second
Updating the firmware.
Connected On Connected to the Network Video Management software or an
ACC™ Server. The default connected setting can be changed to
Off using the camera's web user interface. For more
information see the Avigilon High Definition H4 and H5 IP
Camera Web Interface User Guide.
Troubleshooting Network Connections and LED Behavior
Note: For any of the below LED behaviors, ensure that the camera is getting power and is using a
good network cable before trying another solution.
LED Behavior Suggested Solution
Green LED is off and amber is on Perform a factory reset of the camera using the physical
firmware revert button. Resetting through the camera's web
interface will not produce the desired result.
Main Unit LED Indicators 52