5. Connect the HD BNC cable.
Note: To ensure the micro bullet imager maintains protection from dust and water, make sure
to connect the IP66 rated end of the HD BNC cable to the micro bullet. For more information,
see Recommended Use of HD BNC Cables on page15.
Mounting to a Thin Metal Sheet
The micro bullet imager has a mounting point on the body of the imager that can be used to mount the micro
bullet to a thin mounting surface such as a metal sheet. For this installation the mounting surface should be
no more than 3 mm (0.12") thick.
Mounting to a Thin Metal Sheet 32
To Next Page
Loading...
