1. Drill one pilot hole into the mounting surface for the mounting screw. The pilot hole should be 3.2 mm
(1/8") in diameter, for an M3 mounting screw.
The mounting surface should be no more than 3 mm (0.12") thick. A countersink hole may be required
if the mounting surface is thicker than 3 mm (0.12").
2. Align the screw hole on the micro bullet to the drilled pilot hole and use the provided M3 mounting
screw to secure the imager to the mounting surface.
3. Tighten the mounting screw to secure the micro bullet in place.
Mounting to a Thin Metal Sheet 33
To Next Page
Loading...
