5-47
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
STEP loop
Whether or not the loop exists at the end of the step operation and the operation
end status can be set.
Item (Bank) Display Contents Initial value User level
STEP loop
(Setup bank)
0: Stop (No loop)
1: Loop
2: Final step continued. (No loop)
0 High function
• When this setting is set at “0”, the operation is stopped (READY mode) if the
operation of the SOAK portion of the final step is completed.
• When this setting is set at “1”, the operation is returned to the RAMP portion
of step 1 if the operation of the SOAK portion of the final step is completed. At
this time, the RAMP operation is performed from SP to SP-1 of the final step
regardless of the setting of [
C34
: STEP PV start]. Since the number of loop cycles
is not limited, the loop operation is continued until the READY mode is selected.
• When this setting is set at “2”, the operation is continued with SP of the final step
kept remained until the READY mode is selected if the SOAK portion of the final
step is completed.
To Next Page
Loading...
Need help?
General
